What washer .. monobloc attaching

General purpose topics/chat goes in here
Post Reply
Taid
Member
Posts: 343
Joined: Mon Oct 07, 2019 3:35 pm
Location: Shropshire UK

What washer .. monobloc attaching

Post by Taid »

Capture.JPG

Just about to replace the carb, after fitting new needle jet, and realized there are no washers for under the nuts.

The parts catalogue doesn't illustrate any, but does list PartNo. 000012.

What type of washer should be there please?
You do not have the required permissions to view the files attached to this post.
______________________________________________________________________________________________________________________________

Nostalgia taking over ..

Currently ..1956 AJS 16MS Bitsa .. HSU 414 .. rebuilt/re-registered 1987
Mick D
Member
Posts: 2592
Joined: Mon Mar 24, 2014 5:44 pm
Location: Aberdeenshire

Re: What washer .. monobloc attaching

Post by Mick D »

Hi

000012 is a 1/4" standard plain washer.

Regards Mick
Taid
Member
Posts: 343
Joined: Mon Oct 07, 2019 3:35 pm
Location: Shropshire UK

Re: What washer .. monobloc attaching

Post by Taid »

Mick D wrote:Hi

000012 is a 1/4" standard plain washer.

Regards Mick
Thanks, yet again, M..

Must have a hunt through my junk ..

T
______________________________________________________________________________________________________________________________

Nostalgia taking over ..

Currently ..1956 AJS 16MS Bitsa .. HSU 414 .. rebuilt/re-registered 1987
Post Reply