Page 2 of 4

Re: Kickstart

Posted: Mon Dec 17, 2018 9:19 am
by Martin.S
Mine is 8 1/2" and 1 3/8" offset - ok 21cm and 3.4cm if you must!

Re: Kickstart

Posted: Thu Dec 27, 2018 3:20 pm
by RL
following the same dimensions as Clanger9's mine 200mm with an off set of approx 40mm and fitted to a 1967 250CSR

Re: Kickstart

Posted: Thu Dec 27, 2018 3:23 pm
by clanger9
Wow, so *at least* three different ones then... :roll:

Re: Kickstart

Posted: Mon Dec 31, 2018 3:17 pm
by Woodland
Hi All
Thanks Pete for showing these :)

''Kickstart, may get someone out of trouble..... Hen's teeth I believe.

https://www.ebay.co.uk/itm/AJS-MODEL14- ... SwW0Vb5a4H ''

I have purchased one and they are short by about 1" to the original, also they will foul the silencer!

I intend to cut mine and weld in a section to make it the right length, then try and bend out slightly so it misses / does not foul the silencer.

I am lucky to know someone who has an original, so will try to make it look like this, obviously when I have finished I will have to get re-chromed

Gary

Re: Kickstart

Posted: Mon Dec 31, 2018 4:02 pm
by Peter Morris
Woodland wrote:
I intend to cut mine and weld in a section to make it the right length, then try and bend out slightly so it misses / does not foul the silencer.

I am lucky to know someone who has an original, so will try to make it look like this, obviously when I have finished I will have to get re-chromed

Gary
I would imagine that anything is possible if you are prepared to get it welded and re-chromed........ as long as the splines fit properly. I am lucky enough to have a village blacksmith where I live, he welded 2' extra length into the kickstart of my G15 to give a bit more leverage, once it was chromed only the most observant rivet counter would notice. He also lengthened a roadster prop stand for my G3C with no problems whatsoever.

Re: Kickstart

Posted: Mon Dec 31, 2018 5:36 pm
by SPRIDDLER
Peter Morris wrote: I am lucky enough to have a village blacksmith where I live, he welded 2' :o extra length into the kickstart of my G15 to give a bit more leverage, .......
It's a hand start now then?
;)

Re: Kickstart

Posted: Mon Dec 31, 2018 6:05 pm
by Peter Morris
It might be for Geoff Capes Nev 😂

Re: Kickstart

Posted: Mon Jan 14, 2019 2:50 am
by shifter
Looks to me one of them would be handy to have for a 250/350? eBay item number:
153338728276

Re: Kickstart

Posted: Sun Feb 03, 2019 7:51 pm
by Martin.S

Re: Kickstart

Posted: Sun Feb 03, 2019 7:59 pm
by ajscomboman
Wouldn't dive in too fast. A little bird has it that the spares service may well be stocking kickstarts in the near future if discussions go well. .