Hi Everyone
Can anyone advise the correct jet/needle/slide sizes to suit my M6?
It starts reasonably well, but when ridden quickly overheats. I tried raising the needle but that has made it difficult to start and very reluctant to run under load.
Any gems of advice?
Cheers
Tim
M6 Bing carburettor jet sizes
-
- Member
- Posts: 31
- Joined: Thu Mar 31, 2022 5:47 am
- Location: Nsw AUSTRALIA
-
- Member
- Posts: 1608
- Joined: Mon Jan 01, 1990 12:00 am
- Location: WEST SUSSEX UK
Re: M6 Bing carburettor jet sizes
suggested sizes in document , assuming 2 jet binks carb page 11
http://archives.jampot.dk/book/Spares_l ... s_List.pdf
http://archives.jampot.dk/technical/Car ... rettor.pdf
or maybe some info in this one
https://www.enfieldschrauber.ch/media/D ... ffffd2.pdf
http://archives.jampot.dk/book/Spares_l ... s_List.pdf
http://archives.jampot.dk/technical/Car ... rettor.pdf
or maybe some info in this one
https://www.enfieldschrauber.ch/media/D ... ffffd2.pdf
-
- Member
- Posts: 31
- Joined: Thu Mar 31, 2022 5:47 am
- Location: Nsw AUSTRALIA
Re: M6 Bing carburettor jet sizes
Thanks for that - some reading for this evening!g80csp11 wrote: ↑Fri Nov 10, 2023 9:21 am suggested sizes in document , assuming 2 jet binks carb page 11
http://archives.jampot.dk/book/Spares_l ... s_List.pdf
http://archives.jampot.dk/technical/Car ... rettor.pdf
or maybe some info in this one
https://www.enfieldschrauber.ch/media/D ... ffffd2.pdf
Tim