Main bearings
- Joker_Bones
- Member
- Posts: 552
- Joined: Sat Apr 27, 2013 3:51 pm
- Location: DORSET UK
Re: Main bearings
This is a single, it had stamping inside each case.
You do not have the required permissions to view the files attached to this post.
-
- Member
- Posts: 64
- Joined: Thu May 12, 2022 7:43 pm
- Location: British Columbia CANADA
Re: Main bearings
Thank you. I believe the cases were used together in the past and, at this stage, I cannot verify they are a matched set. Still, how can I determine whether the crankshaft is free enough to continue?
-
- Member
- Posts: 1601
- Joined: Mon Jan 01, 1990 12:00 am
- Location: WEST SUSSEX UK
Re: Main bearings
were conrods free to turn and center web before you assembled it in to crankcase
-
- Member
- Posts: 64
- Joined: Thu May 12, 2022 7:43 pm
- Location: British Columbia CANADA
Re: Main bearings
Con rods are good. It got stiff when I tightened down the web and worse when I applied the timing side case. I’m pretty sure the drive side case was warped from welding and I will have to discard it. Please see my inquiry about my spare case. Thanks for your interest.