Page 3 of 3
Re: 1965 G2CSR Clutch play
Posted: Fri Nov 13, 2020 8:32 pm
by clanger9
You are truly down the rabbit hole now...
I found a couple more photos of clutch plates. This was as far as I got with my attempts to identify them all.
IMG_0248.jpg
IMG_0249.jpg
PS: yes, you'll need to resize photos to 640x480 or 800x600 to post them here.
Re: 1965 G2CSR Clutch play
Posted: Sat Nov 14, 2020 5:46 am
by ColourNcoat
clanger9 wrote:You are truly down the rabbit hole now...
I found a couple more photos of clutch plates. This was as far as I got with my attempts to identify them all.
IMG_0248.jpg
IMG_0249.jpg
PS: yes, you'll need to resize photos to 640x480 or 800x600 to post them here.
You have really excelled in you pursuit in helping me. Thank you
It's a toss between basket 3 or 4 with the duplex chain.
I will take some measurements when I get into work this morning to clarify.
Looking back at your archive pictures. I have noticed the two duplex baskets have ( teeth ) at the bottom of the clutch centre. ( mine do not )
The internal shoulder of the baskets ( 3 and 4 ) are in good condition. My internal shoulder is like a brake disk. This tells me the plate is spinning in opposition and making contact with the basket.
I will double check when I get in this morning.
Re: 1965 G2CSR Clutch play
Posted: Sat Nov 14, 2020 7:32 am
by ColourNcoat
The measurements are as follows...
Basket height from internal shoulder...1.0265" or 26.07mm.
Height/depth of clutch centre...1.589" or 40.36mm.
Cheers
Roger.
P.S. file still too large to upload
Re: 1965 G2CSR Clutch play
Posted: Sat Nov 14, 2020 11:11 am
by clanger9
If you have a "no teeth" basket with a duplex sprocket, then I'm pretty certain that is the correct CSR part (043444).
It should have the 7-plate CSR clutch pack (3x 043191, 3x 043192, 1x 043193). All of these are available from club spares.
From your description, it sounds like someone has tried to fit a standard 250 pack to your bike - understandable, given that there's no factory documentation anywhere that explains the differences!
Re: 1965 G2CSR Clutch play
Posted: Sat Nov 14, 2020 12:33 pm
by ColourNcoat
clanger9 wrote:If you have a "no teeth" basket with a duplex sprocket, then I'm pretty certain that is the correct CSR part (043444).
It should have the 7-plate CSR clutch pack (3x 043191, 3x 043192, 1x 043193). All of these are available from club spares.
From your description, it sounds like someone has tried to fit a standard 250 pack to your bike - understandable, given that there's no factory documentation anywhere that explains the differences!
There's no surprises there then..... Almost a completely new bike by the time I am finished.
My Kawasaki didn't cost as much as this
Thank you for,everything again.